Tivoli Audio BluCon Manuel du propriétaire télécharger pdf (Page 7)

7 – ENGLISH

Pairing a Bluetooth Wireless Technology enabled iPhone/iPod touch/iPad with

the BluCon

1. Follow Steps 1 and 2 above.

2. Select “Settings”.

3. Select "General".

4. Select “Bluetooth”.

5. Switch Bluetooth “On” to initiate searching.

6. Select “Tivoli Bluetooth (Not Paired)” when it appears on the display. If you are prompted to

enter a PIN, enter “0000”. “Tivoli Bluetooth” will change from “Not Paired” to “Connected”.

The volume output level of music ﬁles varies. If you prefer an even higher output level, check the

settings in your iPhone/iPod touch/iPad: Set the EQ Off, the SoundCheck Off, and the Volume

limit Off.

If you encounter a problem Pairing, press the small arrow to the right of “Tivoli Bluetooth” on

your iPhone/iPod touch/iPad display and select “Forget this Device”, then repeat the Pairing

process. Depending on your device, you may need to make multiple attempts at Pairing

and/or Connecting to the BluCon, but please give your device adequate time to Pair or

Connect before repeating the process.

When streaming music, you can press the blue arrow to the right of the next track button >>/ on

the iPhone/iPod touch/iPad display to alternate between the iPhone/iPod/iPad and Bluetooth.

• The BluCon will remember pairing information for up to 8 devices. Additional devices can be

paired, but the least-recently used device will be replaced by the newly paired device.

• If the audio drops out or stops during playback, move your device closer to the BluCon, or

check to be sure another wireless device is not interfering with the signal.

• If you are using the BluCon near a radio and experience reduced reception or noise, move

the BluCon further away from the radio.

• When switching from the Auxiliary position where the BluCon is connected, to AM, FM, or

another source, you may need to adjust (lower) the Aux device’s volume level.

• The BluCon remains in standby whenever its power supply is connected, though the Tivoli

Audio logo will only illuminate when the BluCon is connected to a device via Blootooth wire-

less technology.

PLACEMENT

Position the BluCon where it will be able to receive Bluetooth wireless technology signals. If you

experience any noise, move the BluCon further away from the device it’s audio cable is connected to.

CLEANING

Never use any harsh cleansers or solvents on your BluCon. Normal every day wear and tear or

damage resulting from cleaning or chemicals is not covered under the factory warranty. To clean

the BluCon, use a soft cloth and do not rub hard.

NOTE: Tivoli Audio cabinets use real wood veneers. Since natural wood varies greatly, it is not pos-

sible to achieve an exact wood color/grain match between models. You may also notice the wood

darken over time with exposure to sunlight. Again, this is normal for real wood.

1 2 3 4 5 6 7 8 9 10 11 12 ... 77 78

Pas de commentaire

Tivoli Audio BluCon Manuel du propriétaire Page 7